Publicité
Les langues disponibles
Les langues disponibles
Slew Rate
Low Battery Shutdown
Voltage
Mode Select
Firmware Version
Step 3: Press and hold the toggle for 4 seconds. When the icons blink, the value of each item can be
changed by slightly pressing the toggle.
Step 4: To save the value and return to general mode, press and hold the toggle for 4 seconds.
Note: If the machine is left idle for over 30 seconds during setup, it will turn off the backlight and
return to general mode automatically.
Note: If user wants to return to general mode without saving changes, there are two methods:
1. Wait for the backlight to turn off
2. Press and hold the "Display" toggle for 10 seconds
1.
Overheat Protection: The EPS output will be interrupted. After 30 seconds, the machine shuts
down and the LCD display output voltage is zero.
2.
Over-Load Protection：The EPS output will be interrupted. After 30 seconds, the machine shuts
down and Over Load Icon lights on the LCD display.
3.
Battery Missing：You should hear a long beep and Battery Indicator flashes。
4.
Low Battery Protection: The EPS output will be interrupted. After 30 seconds, the machine shuts
down and the LCD display output voltage is zero.
5.
The following table shows each corresponding warning message on the LCD display and the
alarm reacts during the machine shut down：
LCD Warning
Display
Over Load Icon
Battery Icon Flash
Zero Output Voltage
All manuals and user guides at all-guides.com
FAULT WARNING DISPLAY AND ALARM
Alarm
Constant tone
Beep Once
Constant tone
%
None
V
ON BAT
None
None
Here displays the firmware version. It
can not be configured.
Condition
Over Load Output-Off
- Load exceed the
rating of EPS.
Battery
Missing-
Line
Mode
Battery
Missing.
High Temperature
Output-Off
10
Solution
Check total load to
confirm the rating of
EPS.
Turn
the
EPS
In
check battery wiring
and
presence
battery
Check fans function
and air vent
clearances.
off,
of
Publicité
