GYS GYSPACK PRO 800 Manuel D'utilisation page 13

Operating manual
BATTERY REPLACEMENT:
2
Product Battery
GYSPACK PRO 800 6-SPB-25
To replace the battery :
• The booster must be disconnected form the power supply.
• Unscrew the back panel (10 screws) and remove it.
Once the back panel is removed, the battery front appears (illustration). Remove the positioning belt 1
•
The battery is connected to the GYSPACK at two points: at the + and - terminals. 2 3 To remove the battery,
•
remove the 2 screws that enable the connection between the battery and the GYSPACK at the terminals + and -.
When handing over a new battery, make sure that the polarity of the battery and the GYS-
PACK are matched. Terminal - on the left, terminal + on the right (illustration). Put the 2
screws and washers back on, tighten the nuts (recommended tightening torque of 4 Nm).
• Place the booster's backpanel screws back on.
Translation of the original
instructions
Type Voltage (V)
Lead acid battery
1
Capacity (Ah)
12 28
GYSPACK PRO 800
Dimensions (cm) Battery ref
20 x 14 x 16 53140
3
13