Télécharger Imprimer la page

MINN KOTA MKA-61 Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

2
ITEM(S) NEEDED
c.
Take the Bottom Plate (Item #4) and set it on a level
surface. The Bottom Plate should sit so that the
Spring Pin faces upward. The Spring Pin is present
along the edge of the Bottom Plate that points
Outboard. Take the Top Plate with the trolling motor
installed and place it on the Bottom Plate. Place the
Top Plate so that the holes for the Padlock Slot on
the Top Plate and Bottom Plate align.
3
ITEM(S) NEEDED
#8 x 2
d.
Take the two 1/4-20 X 1.50-inch Socket Head Cap
Screws (Item #10), each with a Jam Nut (Item #8)
in place. Slide both plates to align the holes in the
Top Plate and Bottom Plate. Apply anti-seize to all
hardware. Install each 1/4-20 X 1.50 Socket Head Cap
Screw with the Jam Nut in place into the plates using
a 3/16" Allen Wrench. Tighten the Allen Wrench turning
clockwise until there is no movement between the
plates. Tighten an additional quarter turn past tight.
Once the 1/4-20 X 1.50 Socket Head Cap Screws are
tight, take a 7/16" Open End or Box End Wrench and
tighten the Jam Nut. Make sure all hardware
is secure.
6 | minnkota.johnsonoutdoors.com
#4 x 1
#10 x 2
2c
Top
Top
Plate
Plate
Padlock
Padlock
Slot
Slot
Padlock Slot
Padlock Slot
Inboard
Inboard
3d
Jam Nut
Jam Nut
Socket Head Cap Screw
Socket Head Cap Screw
Inboard
Inboard
Outboard
Outboard
Hold-Down
Hold-Down
Strap
Strap
Spring Pin
Spring Pin
Bottom Plate
Bottom Plate
Top Plate
Top Plate
Outboard
Outboard
Bottom
Bottom
Plate
Plate
©2023 Johnson Outdoors Marine Electronics, Inc.

Publicité

loading

Ce manuel est également adapté pour:

Mka-6218620421862052