Publicité
Les langues disponibles
Les langues disponibles
Completing the Installation for all Motors
1
a.
Take the Top Plate with the motor attached and
slide it into the Bottom Plate. The Top Plate slides
outboard from the back end of the Bottom Plate.
Once slid all the way outboard, secure the Top Plate
to the Bottom Plate.
b.
Take the two 1/4-20 X 1.50-inch Socket Head Cap
Screws (Item #10), each with a Jam Nut (Item #8)
in place. Slide both plates to align the holes in the
Top Plate and Bottom Plate. Apply anti-seize to all
hardware. Install each 1/4-20 X 1.50 Socket Head Cap
Screw with the Jam Nut in place into the plates using
a 3/16" Allen Wrench. Tighten the Allen Wrench turning
clockwise until there is no movement between the
plates. Tighten an additional quarter turn past tight.
Once the 1/4-20 X 1.50 Socket Head Cap Screws are
tight, take a 7/16" Open End or Box End Wrench and
tighten the Jam Nut. Make sure all hardware
is secure.
If personal preference is to mount the
NOTICE:
motor on the Starboard side of the boat, please see
the "Rotate the Pedal Control Sleeve Assembly for
a Starboard Mount" in the Owner's Manual after the
Mount is secured to the deck of the boat for all Ultrex
and Ultrex QUEST series trolling motors.
Help prevent motor
NOTICE:
theft. A padlock can be
installed in the hole in the
bracket's inboard corner.
Once the installation of the Quick Release Bracket is complete, reinstall the Lift Cylinder or Gas Spring(s) for all Fortex,
NOTICE:
Ultrex, and Ultrex QUEST series trolling motors. If the Steering Module or BowGuard were removed for ease of installation,
reassemble it to the trolling motor. For Fortrex trolling motors, please first review the "Installing the Mount" section and then the
"Installing the Gas Spring Pin" section of the Fortrex Owner's Manual (#2287106). For Ultrex trolling motors, please review the
"Reassemble the Steering Module" section of the Ultrex Owner's Manual (#2297162). For Ultrex QUEST trolling motors, please
first review the "Reassemble the Steering Module" section and then the "Reinstalling the Gas Springs" section of the Ultrex
QUEST Owner's Manual (#2297166). Find Owner's Manuals online at minnkota.johnsonoutdoors.com.
For warranty information, please visit
minnkota.johnsonoutdoors.com
Part #2377181
minnkota.johnsonoutdoors.com
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 44005
1a
Boat
Boat
Deck
Deck
Top Plate
Top Plate
Padlock
Padlock
Slot
Slot
Outboard
Outboard
1b
Jam
Jam
Nut
Nut
Socket Head
Socket Head
Cap Screw
Cap Screw
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
Outboard
Outboard
Spring Pin
Spring Pin
Bottom
Bottom
Plate
Plate
Padlock
Padlock
Slot
Slot
Inboard
Inboard
Padlock
Padlock
Slot
Slot
Inboard
Inboard
©2023 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev A
08/23
Publicité
