Publicité
Les langues disponibles
Les langues disponibles
5
h.
If installing an Edge, Fortrex, Maxxum, or
Ultrex trolling motor, drill through the deck of
the boat using a Drill and a 9/32" Drill Bit on the
marked locations.
i.
If installing a QUEST series Ultrex trolling motor,
drill through the deck of the boat using a Drill and a
21/64" Drill Bit on the marked locations.
j.
Return the Bottom Plate to the Boat Deck aligning
the Mounting Holes with the Drilled Holes.
6
ITEM(S) NEEDED
#18 x 6
k.
If installing an Edge, Fortrex, Maxxum or Ultrex
trolling motor, take six ¼-20 x 2¼" Phillips Pan
Head Screws (Item #12), six ¼" Flat Washers
(Item #16), and six ¼-20 Nylock Nuts (Item #18).
Apply anti-seize (Item #28) to all hardware. Insert
each Phillips Pan Head Screw into the Bottom Plate
and through the Boat Deck. Place one Flat Washer
and one Nylock Nut on the end of each Screw below
the Boat Deck. While holding each Nylock Nut with
7/16" Box End or Open End Wrench, use a #3 Phillips
Screwdriver to tighten each Screw. Make sure all
hardware is secure.
l.
If installing a QUEST series Ultrex trolling motor,
take six 5/16-18 x 2.25" Phillips Pan Head Screws
(Item #22) and six 5/16" x 1.5" Flat Washers
(Item #26) and six 5/16-18 Nylock Nuts (Item #20).
Apply anti-seize (Item #28) to all hardware. Insert
each Phillips Pan Head Screw into the Bottom Plate
and through the Boat Deck. Place one Flat Washer
and one Nylock Nut on the end of each Screw. While
holding each Nylock Nut with a 1/2" Box End or Open
End Wrench, use a #4 Phillips Screwdriver to tighten
each Screw. Make sure all hardware is secure.
10 | minnkota.johnsonoutdoors.com
#16 x 6
#12 x 6
5h
Drilled
Drilled
Locations
Locations
Inboard
Inboard
5j
Marked
Marked
Location
Location
Boat
Boat
Deck
Deck
Bottom
Bottom
Plate
Plate
Padlock Slot
Padlock Slot
Inboard
Inboard
#20 x 6
#26 x 6
6k
Screw
Screw
Inboard
Inboard
The mounting surface for the Bottom Plate must
NOTICE:
be completely flat; otherwise, the Top Plate will not fit
correctly. Rubber washers can be used to shim the Bottom
Plate flat before the hardware is tightened.
Outboard
Outboard
Outboard
Outboard
Spring
Spring
Pin
Pin
Mounting
Mounting
Holes &
Holes &
Drilled
Drilled
Locations
Locations
#22 x 6
#28 x 1
Outboard
Outboard
Bottom
Bottom
Plate
Plate
Boat
Boat
Deck
Deck
Flat Washer
Flat Washer
Nylock Nut
Nylock Nut
©2023 Johnson Outdoors Marine Electronics, Inc.
Publicité
