Publicité
Les langues disponibles
Les langues disponibles
EN
LCDI Power Cord and Plug
This air conditioner is equipped with an LCDI (L eakage Current
Detection and Interruption) power cord that is required by UL. This
power supply cord contains state- of-the art electronics that sense
leakage current. If the cord is damaged and leakage occurs, power will
be disconnected from the unit.
The test and reset buttons on the LCDI Plug are used to check if the plug
is functioning properly. To test the plug:
1. Plug power cord into a grounded 3 prong outlet
2. Press RESET (on some units a green light will turn on).
3. Press the TEST Button, the circuit should trip and cut all power to the
air conditioner (on some units a green light may turn off.
4. Press the RESET button for use. You will hear a click and the AC is not
ready for use.
NOTES:
● The RESET button must be engaged for proper use.
The power supply cord must be replaced if it fails to trip when the TEST
button is pressed and the unit fails to reset.
● Do not use the power supply cord as an ON/OFF switch. The power
supply cord is designed as a protection device.
● A damaged power supply cord must be replaced with a new power
supply cord.
NOTES:
Your units power cord and
plug may differ from the
one shown.
05
Publicité
