Publicité
Les langues disponibles
Les langues disponibles
EN
Normal Operating Sounds
• You may hear a pinging noise caused by water hitting the condenser,
on rainy days, or when the humidity is high. This design feature helps
remove moisture and improve efficiency.
• You may hear the thermostat click when the compressor cycles on and
off.
• Water will collect in the base pan during rain or days of high humidity.
The water may overflow and drip from the outside part of the unit.
• The fan may run even when the compressor is not on.
1. Digital Display: Without timer setting, the operation mode is
Cooling, Dry, Fan and Auto, and the set temperature will be displayed.
Time will be displayed under timer setting.
2.
andy
Button: Use these buttons on the .control panel and
remote to increase or decrease the Set Temperature or Timer.
Temperature range: 61°F~88°T or 16°C~31°C.
3. Power Button: Turn the air conditioner on and off.
4. Mode Button: Press the mode button to cycle through the various
modes: Cool, Dry, Fan and Auto.
Cool Mode: The cooling function allows the air conditioner to cool the
room and at the same time reduces Air humidify. Press the MODE button
to activate the cooling function. To optimize the function of the air
conditioner, adjust the temperature and the speed by pressing the
button indicated.
Dry Mode: This function reduces the humidity of the air to make the
room more comfortable. Press MODE button to set the DRY mode . An
automatic function of alternating cooling cycles and air fan is activated.
Fan Mode: The conditioner works in only ventilation. Press MODE button
to set the FAN mode. With pressing FAN SPEED button the speed
changes in the following sequence: High, Med and Low in FAN mode. The
remote control also stories the speed that was set in the previous mode
of operation.
17
Publicité
