Publicité
Les langues disponibles
Les langues disponibles
EN
When handling the unit, be careful to avoid cuts from the sharp metal
edges and aluminum fins on the front and rear coils.
How to Install
NOTE: Top Rail and Sliding Panels at each side are offset to
provide the proper pitch to the rear of (5/16"). This is necessary
for proper condensed water utilization and drainage. If you are
not using the Side Panels for any reason, this pitch to the rear
must be maintained!
1. Place unit on floor, a bench or a table. There is a Left and Right
Window Filler Panel - be sure to use the proper panel for each side.When
installed the flange for securing the panel in place to the window sill
will be facing into the room.
A. Hold the Panel in one hand and gently pull back the center to free the
open end. See Figure 3.
CAUTION
10
TOOLS NEEDED:
● Phillips Screw
Driver
● Drill (If pilot holes
are needed)
Publicité
