Editing Recorded Mds; Before You Start Editing - Sony MDS-JB980 Mode D'emploi

Editing Recorded MDs

Before you start editing

Before editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
Note
When the Group function is on, editing can be
performed only for the tracks registered into the
selected group.
To cancel the last edit
Use Undo Function to cancel the last edit and
restore the contents of the MD to the condition
before the edit.
To quit while editing
Press MENU/NO or x.
About indications which
appear while editing
When "C11/Protected" appears in the
display
The MD is record-protected. Slide the record-
protect tab and close the slot. For details, see
"To prevent accidental erasure of the recorded
material" on page 12.
When "TrProtected" appears in the
display
You cannot perform editing operations on
protected tracks (tracks checked out from a
USB connected computer, etc.) other than
"Moving recorded tracks" on page 30 and
"Naming a track or an MD" on page 30 using
this deck.
When "Cannot Edit" appears in the
display
You cannot edit the MD in Shuffle or
Programme Play mode. Press PLAY MODE
repeatedly until both "PGM" and "SHUF"
disappear.
After editing
Press EJECT A to remove the MD or press
?/1 to turn off the deck.
"TOC" or "TOC Writing" starts flashing. The
TOC is updated and recording is completed.
Before disconnecting the mains lead
MD editing is completed when the MD Table of
Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the deck. Do not disconnect the mains
lead before updating the TOC (while "TOC" is
lit) or while updating the TOC (while "TOC
Writing" is flashing) to ensure a complete
editing.
25
GB