Changing The Recorded Level After Recording - Sony MDS-JB980 Mode D'emploi

Releasing the registrations of
all tracks on an MD
— All Release Function
You can release the group registrations of all
tracks on an MD at once.
1
While the deck is stopped, press
GROUP ON/OFF.
The GROUP ON/OFF button lights up.
2
Press MENU/NO.
"Edit Menu" appears in the display.
3
Turn AMS (or press ./>
repeatedly) until "Gp All REL?"
appears, then press AMS or YES.
"All REL??" appears.
4
Press AMS or YES again.
"Complete!" appears.
36
GB
Changing the recorded
level after recording
— S.F EDIT
You can change the volume of recorded tracks
using S.F (Scale Factor) Edit. The original track
is recorded over at the new recording level.
When changing the recording level, you can
select Fade-in Recording to gradually increase
the signal level at the start of recording, or
Fade-out Recording to gradually decrease the
signal level at the end of recording.
Changing the overall
recording level
1
While the deck is stopped, playing, or
paused, press MENU/NO.
"Edit Menu" appears in the display.
2
Turn AMS (or press ./>
repeatedly) until "S.F Edit?" appears,
then press AMS or YES.
3
Turn AMS (or press ./>
repeatedly) until "Tr Level?" appears,
then press AMS or YES.
4
Turn AMS (or press ./>
repeatedly) until the track number you
want to change the recording level
appears, then press AMS or YES.
"Level 0dB" appears in the display.
5
While monitoring the sound, turn AMS
(or press ./> repeatedly) to
change the recorded level without
turning on the two rightmost indicators
on the peak level meters.
You can set the level at any value between
–12 dB and +12 dB, in 2 dB increments.
Avoid turning on these indicators