Sony MDS-JB980 Mode D'emploi page 18

If the CD player does not start
playing
Some CD players may not respond when you
press CD SYNCHRO START on the remote.
Press X on the CD player's remote instead to
start play on the CD player.
Operations you may want to do
during CD Synchro-recording
To
Stop recording
Pause recording
Resume recording after
pausing
Tips
• You can use the remote of the CD player during CD
Synchro-recording.
Press To change the
deck to
H
Recording
x Recording pause
X
Recording pause
• During CD Synchro-recording, track numbers are
marked in the following ways:
— When the CD player is connected to the
DIGITAL IN connector, track numbers are
automatically marked as they appear on the CD.
— When the CD player is connected to the
ANALOG IN jacks, track numbers are
automatically marked when "T.Mark LSyn(c)"
has been selected (page 13).
— When you resume recording after recording
pause, a new track number is automatically
marked, regardless of the track marking
parameter setting ("T.Mark LSyn(c)" or "T.Mark
Off").
18
GB
Press
CD SYNCHRO STOP on
the remote
CD SYNCHRO STANDBY
on the remote
CD SYNCHRO START on
the remote
And change the
CD player to
Play
Stop
Pause
• You can change the CD during CD Synchro-
recording.
1 Press x on the CD player's remote.
2 Change the CD.
3 Press H on the CD player's remote.
The MD deck resume recording.
• By reprogramming the MD's remote, you can use
the procedure above to perform synchro-recording
with a Sony video CD player.
Press number button 2 on the remote while pressing
down ?/1 on the remote. You can now operate the
MD deck and the video CD player with the remote.
To control the CD player again, press number button
1 on the remote while pressing down ?/1 on the
remote.
Notes
• When performing CD Synchro-recording with a CD
player with a mode selector, be sure to set the
selector to CD1.
• When you record tracks from certain CD or multi-
disc players, the entire material may be recorded as a
single track.