NUK DECT Babyphone ECO Control Mode D'emploi page 33

The parent unit
beeps
The parent unit
is too sensitive
to sounds
No sounds or
baby noises
coming from the
parent unit
The baby monitor
produces a high-
pitched noise
The alkaline bat-
teries in the baby
unit are running
low quickly
The recharge-
able batteries in
the parent unit
are running low
quickly
The talk-back
feature is not
working
NUK Babyphone 10.256.266 (BM-100).indb 27
All manuals and user guides at all-guides.com
• The connection with the baby unit has been lost. reduce the
distance between the parent and baby units.
• The baby unit may be switched off. Press the POWEr key to
switch on the baby unit.
• The rechargeable batteries in the parent unit are running low.
To recharge the unit, connect the parent unit to the mains
power supply with the power adaptor supplied.
• The microphone sensitivity level of the baby unit may be set too
high. Decrease the microphone sensitivity level of the baby unit
using the parent unit.
• The volume level of the parent unit may be set too low or to off.
Increase the volume level of the parent unit (see section 5.3).
• The microphone sensitivity level of the baby unit may be set
too low. Increase the sensitivity level of the baby unit (see
section 5.5).
• The parent unit and the baby unit may be out of range of one
another. reduce the distance between the units.
• Please also note that the units will always need approx. 30 sec-
onds to connect to one another (see section 6.1).
• The parent and baby units are too close to each other. make
sure the parent unit and the baby unit are at least 1.5 metres
away from each other.
• The speaker volume of the parent unit may be set too high.
Decrease the volume of the parent unit (see section 5.3).
• The microphone sensitivity level of the baby unit may be set too
high, which will cause the baby unit to transmit more frequently.
Decrease the microphone sensitivity level of the baby unit us-
ing the parent unit.
• The volume level of the baby unit may be set too high, which will
consume power. Decrease the volume level of the baby unit.
• The volume level of the parent unit may be set too high, which
will consume power. Decrease the volume level of the parent
unit.
• Check that the volume level is high enough at the baby unit.
27
17.12.2009 13:55:04