NUK DECT Babyphone ECO Control Mode D'emploi page 30

5.5 sensitiVity
you can adjust the sensitivity from the parent unit to monitor the sound of the
baby unit.
• There are five sensitivity levels which are indicated by lit LEDs:
Level 1 represents the lowest sensitivity level
Level 5 represents the highest sensitivity level (i.e. the microphone is activated
at all times)
• You will hear two short beeps when the lowest or the highest level is selected.
5.6 paging tHe parent unit
you can use this feature to call the parent unit in case you need help with the baby or
if you have misplaced the parent unit. The parent unit must be switched on to use this
feature.
The volume of these alerts is fixed. If the volume of the parent unit is set to OFF,
the volume will be set to ON and will remain on during paging.
5.7 Full ecO mOde
When the Full Eco mode is activated, there will be no high frequency radiation at
all between the baby and parent units when the baby is quiet.
2 sec.
2 sec.
Please observe that the parent unit must be within the range of the baby unit to
establish a connection between both devices.
NUK Babyphone 10.256.266 (BM-100).indb 24
All manuals and user guides at all-guides.com
Press the VOX button on the parent unit (Fig. 14).
Use the - and + buttons to select the desired level.
Press the VOX button to confirm the setting.
Press the button to sound alerts from the parent unit for 120 sec-
onds (Fig. 15).
you may end this function by pressing the
ing any key on the parent unit.
Press and hold the + button for approx. 2 seconds. The ECO LED will
be lit (Fig. 16).
Press and hold the + button again to switch this feature off. The ECO
LED will turn off.
button again or by press-
24
17.12.2009 13:55:03