NUK DECT Babyphone ECO Control Mode D'emploi page 32

6.3 restOring deFault settings
The Babyphone settings can be restored to their default values as follows:
4 sec.
4 sec.
Baby unit
Sensitivity level:
Baby unit volume:
Full Eco mode:
Parent unit
Parent unit volume :
7 TrOUBLESHOOTING
Connection LED
on the parent unit
does not come on
Connection LED
on the parent unit
flashes
Low battery LED
on the baby unit
flashes
Low battery LED
on the parent unit
flashes
NUK Babyphone 10.256.266 (BM-100).indb 26
All manuals and user guides at all-guides.com
Parent unit
Press and hold the - button for approx. 4 seconds (Fig. 17).
-
A double beep will sound and the unit will be reset.
Baby unit
Press and hold the - button for approx. 4 seconds (Fig. 18).
-
A double beep will sound and the unit will be reset.
Level 3
Level 3
Off
Level 1
• Check whether the parent unit is switched on.
• Check whether the rechargeable batteries supplied are cor-
rectly installed and that they are not empty.
• recharge the parent unit by connecting it to the power supply.
• The parent unit and the baby unit may be out of range of one
another. reduce the distance between the units.
• The baby unit may be switched off. Press the POWEr key to
switch on the baby unit.
• The alkaline batteries in the baby unit are running low.
• replace the alkaline batteries or connect the baby unit to the
mains power supply.
• The rechargeable batteries in the parent unit are running low.
To recharge the unit, connect the parent unit to the mains
power supply with the power adaptor supplied.
26
17.12.2009 13:55:04