Barbecook SUMO BLACK Mode D'emploi page 8

2. Screw the gas hose on the gas tube (A) and tighten it with two
spanners. Hold the tube with one spanner, while turning the hose
with the other spanner (B).
A
6.4 Connecting the hose and cylinder to
the regulator
You need a 17 mm spanner and an adjustable spanner.
1. Screw the hose on the pressure regulator and tighten it with a 17
mm spanner (A).
2. 2 Screw the regulator clockwise on the cylinder and tighten it with
an adjustable spanner (B).
A
6.5 Replacing the cylinder
1. Close the gas supply and set all control knobs to OFF.
2. Disconnect the empty cylinder and connect the full cylinder.
3. Check the cylinder, the hose and all gas connections for leaks.
See "7 Checking for gas leaks".
7 CHECKING FOR GAS LEAKS
7.1 Why check for gas leaks?
Propane and butane are heavier than air. As a result, they do not float
away when leaking from the appliance. Especially on windless days,
a leak can cause the gas to collect in and around the appliance. That
accumulated gas can then ignite and explode.
7.2 When check for gas leaks?
• Before the first use or before the first use after a long period of
non-use.
Also check for gas leaks if your appliance was assembled by
your dealer.
• Each time you replace a gas component.
• At least once a year, preferably at the beginning of the season.
8
All manuals and user guides at all-guides.com
7.3 Safety instructions
•
B
•
•
7.4 Which materials do I need?
To check for gas leaks, you need:
•
•
B
7.5 To check for gas leaks
You check for gas leaks by applying a testing liquid to all gas
components and connections. If the bubbles on a particular
component or connection grow, there is gas leak:
www.barbecook.com
Put the appliance outdoors, in a well-ventilated area. Make sure
there are no flames or heat sources near the appliance.
Never use a lighter or match to check for gas leaks.
Do not smoke and do not light the burners when checking for gas
leaks.
A testing liquid. You can use a ready-made leak spray or a mixture
of water (50%) and dish-washing soap (50%).
The leak test tool that came with your appliance. You use it to
suck up the testing liquid and apply it to the gas component or
connection that you want to check.