Publicité
IMPORTANT SAFEGUARDS
CAUTION /WARNING
ELECTRICAL DANGER
DISCONNECT DAMAGED SUPPLY CORD
The instructions are part of the appliance. Read and follow all
instructions to avoid possible harm and damage. Save these
instructions and pass them on to any subsequent owner.
At least one copy of this manual should be kept in
a location available at all times to maintenance and
management staff.
Avoid risk of fatal
electrical shock and fire
Only plug the base into a suitable, grounded power socket.
•
Make sure that the voltage of the power source is the same
as that specified on the rating plate.
Unplug from outlet when not in use and before cleaning.
•
Allow to cool before putting on or taking off parts, and
before cleaning the appliance.
Always attach plug to appliance first, then plug cord into
•
the wall outlet. To disconnect, turn any control to «off», then
remove plug from wall outlet.
Do not pull the cable over sharp edges, clamp it or allow
•
it to hang down. Keep the cable away from heat and
moisture.
If the supply cord is damaged, it must be replaced by
•
the manufacturer, its service agent or similarly qualified
persons.
Disconnect the base from the power socket, when not in
•
use for long periods. Disconnect by pulling out the plug and
not pulling the cable itself, as this may damage the cable.
EN
3
Publicité
