Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
LED indicator (Fig. 6)
The LED indicator on the tool shows the following functions.
Function
This function works when the tool has
reached the preset fastening torque
Auto-stop fastening
and normal tightening has been
completed. This helps overtightening
to be avoided.
For approximately one second after
auto-stop fastening, the tool does not
Delayed re-start
start even if the switch trigger is
pulled.
Insufficient fastening has been
Warning against
performed when the switch trigger
insufficient fastening
has released before reaching the
preset fastening torque.
This indicates the appropriate time to
Warning for battery
replace the battery cartridge when
cartridge capacity
the battery power becomes low.
Checking the
This function works when the battery
remaining battery
power is almost used up. At this time,
capacity, Autostop
tool stops immediately.
This function works to check the
Check the LED
proper operation of the LED indicator,
indicator, lamp and
lamp and beeper when a battery
beeper operation
cartridge has been inserted into the
tool.
This function works when an
Anti-reset of
abnormal drop of the battery voltage
controller
occurs for some reason, and the tool
stops.
This function works when the
Overheat
temperature of the controller goes up
very highly, and the tool stops.
This function works to avoid the tool's
Operation error of
immediate start upon insertion of
the switch trigger
battery cartridge into the tool with the
switch trigger being pulled.
Warning for limit of
The tool automatically stops without
the fastening
the clutch working when exceeding
capacity
the fastening capacity limit.
013073
Status of the LED indicator/beeper
Status
Lights up in
green for
approximately
one second.
Lights up in red. A long beep
Flickers in red
slowly.
Lights up in red. A long beep
Lights up first in
green, next red.
(And then the
lamp comes
on.)
Flickers in red
and green
alternatively.
Flickers in red
quickly.
Flickers in red
and green
alternatively.
Flickers in red
and green
alternatively.
LED indicator
Beeper
—
A series of long
beeps
A series of very
short beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
A series of short
beeps
Action to be
taken
—
Retighten the
screw.
Replace the
battery with fully
charged one.
Replace the
battery with fully
charged one.
—
Replace the
battery with fully
charged one.
Remove the
battery cartridge
immediately and
cool the tool
down.
Release the
switch trigger.
Remove the
battery cartridge
and then install
it again.
Be sure to use
the tool under
load within its
capacity.
7
Publicité
