Publicité
Les langues disponibles
Les langues disponibles
8.7 ADJUSTING THE AUGER AND PROPULSION CABLE
The augers should rotate only when the auger control lever is engaged and must
stop within 5 seconds of the auger control lever being released. The wheels should
only move when propulsion control lever is engaged and must stop immediately
when the propulsion control lever is released. If the auger or wheels do not stop as
described, adjust the control cable or contact an authorized service dealer to adjust
the control cable.
Over-tightening the auger or propulsion cables may cause the auger or wheels to
rotate even if the control levers are not engaged. Follow the adjustment procedure to
ensure the cables are not over-tightened.
1
1.
Place the unit on a level surface, turn the fuel shut-off valve to CLOSED,
and remove the POWER key.
Speed Selector Knob
2.
Loosen jam nut.
3.
Hold control cable to keep it from rotating, turn collar to remove slack, do
not over-tighten.
4.
Tighten jam nut.
5.
Start the engine, then check operation using the tests below:
a. Test 1: Auger.
i. Press down on the auger control lever - The auger/impeller should
rotate.
ii. Release the auger control lever - The auger/impeller must stop
within 5 seconds.
Chute De ector Knob
b. Test 2: Propulsion. With the speed control lever in 1st gear:
i. Press down on the propulsion control lever - The unit should move
forward.
ii. Release the propulsion control lever - The unit must stop
immediately.
c. Test 3: One-Hand Feature.
i. Engage the auger and propulsion control levers, then release the
auger control lever - Both controls should remain engaged.
ii. Release the propulsion control lever - Both controls must release.
6.
If the unit does not operate as described, DO NOT use it. Contact customer
support to have the unit inspected, adjusted, or repaired.
2
3
47
4
BS6050
Publicité
