Benchmark BS6050 Manuel page 40

7.4 ADJUSTING THE SKID SHOE HEIGHT
1. Place the unit on a level surface, turn the fuel shut-off valve to CLOSED,
and remove the POWER key.
a. If removing snow from a hard surface such as a paved driveway or
walk, adjust the skids shoes higher on the auger housing to lower the
scraper bar closer to the surface.
b. If removing snow from gravel-covered or uneven surfaces, adjust the
skids shoes lower on the auger housing to raise the scraper bar further
from the surface. This will help prevent rocks and other debris from
being picked up and thrown by the auger and impeller.
2.
Allow each loose skid shoe to rest on the ground's surface, then tighten the
mounting nuts.
TM
36
Skid Shoes
Mounting Nuts