Télécharger Imprimer la page

STERWINS 550 RW AUTO-4 Notice De Montage, Utilisation Et Entretien page 197

Pompe pour récupérateur d'eau de pluie

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
• Do not use any sharp tool (cutter, knife...) when unboxing, you may damage the product.
• When unboxing, take the pump with the carrying handle (4)
• Do not use the power cord to lift, carry or transport the machine.
• Do not scrape the power cord across sharp edges and ensure that it does not get pressed.
4.2 INSTALLATION
Assemble the different elements together according to the illustration. In case screw are necessary :
tight it with appropriate tool.
The shorter the hose length and the larger the hose diameter,
the higher the pump capacity
Connecting the discharge hose : illustration 2.1 to 2.3
Required accessories : Connector, PVC hose, sprayer.
Screw the adapter clockwise onto the outlet of the pump casing. Tighten manually and sufficiently.
Different hose diameters can be connected. A large hose diameter is also recommended to allow a high
flow volume.
CAUTION ! Always wear safety glasses and gloves during
installation.
4.3 FIRST USE
WARNING ! Read the « SAFETY INSTRUCTION » section at the
beginning of this manual including all text under subheading
therein before using this product.
Pay particular attention using the machine for the first time : focus and dedicate all your attention to this
first use.
Priming the pump : illustration 3.1 and 3.2
If the water is not pumped out after 20 seconds of starting, lift the pump, wait until the pump empties of
water and plunge the pump back into the water. Restart the pump.
Note: The pump must be fully immersed in water. Otherwise
the pump will not prime, will not be able to operate at its
maximum flow rate and may be damaged !
4.4 OPERATION
Start the product : illustration 4.4
Before any use, make sure that the pump is properly primed (see chapter above)
Operate the product : illustration 4.1 to 4.7
It is recommended to use a rope attached to the handle to install the pump at the bottom of the water.
You can also hang it to the top of the barrel/tank to gain stability
197
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN

Publicité

loading