STERWINS 550 RW AUTO-4 Notice De Montage, Utilisation Et Entretien page 204

FR 8.4 TROUBLESHOOTING
ES
PT
IT
Problems
EL
The pump is not
starting
PL
RU
The pump is not
draining
KZ
UA
The flow is not
suitable
RO
EN
The pump
stops for a brief
moment
8.5 FATAL CIRCUMSTANCES
Power consumption too high
Performance reduced
Leakage of the motor housing
DANGER ! Risk of injury due to electric shock, fire and/or serious
injury. Warning ! Before any trouble shooting, switch off the
product and keep other person away.
Probable causes
- There is no electric current
- There is no water
- The outlet pipe is clogged
- The turbine is blocked
- Presence of an air bubble
- The draining pipe diameter
is not suitable
- The outlet pipe is clogged
- The turbine is blocked
- Use instructions have not
been followed
- The motor automatically
switches to safety position
- The pipe is not suitable
- The water is too hot. The
overheat protection device
is stopping the pump
Problems
Solutions
- Ensure that the electric
current is on.
- Check the water height
- Clean the pipe
- Disassemble the base and
clean the turbine
- Tilt the pump to let out the
air bubble then put it back in
vertical position
- Replace the tube (19mm hose
is recommended)
- Clean the pipe
- Disassemble the base and
clean the turbine
- Check for the depth of
submersion.
- Replace the pipe following
use instructions
- Check that the water
temperature remains under
35°C.
Stop use and contact authorized service center
Сontact authorized service center
Stop use and contact authorized service center
204
Qualification
required
No qualification
required
No qualification
required
No qualification
required
No qualification
required
Action