Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE UNIT (continued)
.
Step 7
Detach the outer duct cover by removing the (2) set screws near
the bottom middle of the attached duct. Inside the duct, there are
tongue and groove clips for stability. Lift on side of the duct to
detach.
Step 8
Bring the two duct pieces together over the support frame brackets
and the upper duct that was attached in step 5. Reattach the (2) set
screws. Make sure the tongue and groove clips are realigned.
Step 9
Set the bottom duct unto the top of the rangehood in the grooved
slot. Removing the filters (D), and from underneath the
rangehood, screw in (14) (type C) screws into the pre-drilled
holes. This will secure the outer duct to the rangehood body.
24
Publicité
