Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE MOUNTING BRACKET (
IMPORTANT: Make sure that holes locations are leveled and correctly centered by the vertical centerline
(this installation instruction applies for concrete wall).
WARNING: AT LEAST TWO PEOPLE ARE REQUIRED TO LIFT AND POSITION THE HOOD ONTO THE
MOUNTING SCREWS.
WARNING: BE CAREFUL WHEN INSTALLING THE DECORATIVE CHIMNEY AND HOOD, THEY MAY HAVE
SHARP EDGES.
CAUTION: DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE DECORATIVE CHIMNEY AT
THIS STAGE.
INSTALLING THE UNIT
Secure the hood to the recommended height of 26 "above the electrical cooking surface and 30" above the
gas cooking surface.
)
continued
Step 1:
Remove the hood from it's packaging and place it gently on a
horizontal work surface. Attach the exhaust pipe to the air outlet
with 2 screws, use tape to seal the joints between the pipe
sections, making sure it is properly connected.
Step 2
By aligning the bottom support frame with the holes in the hood
box, use 4 (type C) screws to attach each bottom support frame
to the hood.
Step 3
Detach the inner duct cover by removing the (2) set screws near
the upper middle of the attached duct. Inside the duct there are
tongue and groove clips for stability. Lift on side of the duct to
detach.
22
Publicité
