Zanussi ZDI12010XA Notice D'utilisation page 23

Alarm code
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittently.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance
before you do the checks. Turn the
Problem
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
After the checks are completed, turn the pro-
gramme knob until the programme marker is
aligned with programme that was in operation
when the problem occurred. The programme
continues from the point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Serv-
ice.
www.zanussi.com
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
programme knob until the programme marker
is aligned with the on/off indicator.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or wait for the end
of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap and contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a low-
er position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
Problem
23