Zanussi ZDI12010XA Notice D'utilisation page 20

3. Start the shortest programme with a rins-
ing phase, without detergent and without
dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
start a programme.
Turn the programme knob until the programme
marker is aligned with a programme on the
control panel. If the on/off indicator comes on
and the start indicator starts to flash the appli-
ance is in setting mode.
If the control panel does not show this condi-
tion, press and hold the start button until the
appliance is in setting mode
Starting a programme without delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker
is aligned with the symbol of the pro-
gramme you want to set.
• On/off indicator comes on.
• Start indicator starts to flash.
4. Press Start to start the programme.
• On/off indicator and start indicator are
on.
Starting a programme with delay start
1. Set the programme
2. Press the delay button to delay the start of
the programme of 3 hours.
• The delay indicator comes on.
3. Press the start button to start the count-
down.
• The start indicator comes on.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance con-
tinues from the point of interruption.
20
Cancelling the delay start while the
countdown operates
1. Press and hold the start button until the
start indicator starts to flash.
2. Press the start button to start the pro-
gramme.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
Cancelling the programme
1. Press and hold the start button until the
start indicator starts to flash.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed
comes on. If you do not deactivate the appli-
ance within 5 minutes all indicators goes off.
This helps to decrease energy consumption.
1. To deactivate the appliance, turn the knob
until the programme marker is aligned with
the on/off indicator.
2. Close the water tap.
Important
• Let the dishes become cold before you re-
move them from the appliance. Hot dishes
can be easily damaged.
• First remove the items from the lower bas-
ket, then from the upper basket.
• There can be water on the sides and on the
door of the appliance. Stainless steel be-
comes cool more quickly than the dishes.
www.zanussi.com