Zanussi ZDI12010XA Notice D'utilisation page 22

Cleaning the filters
1
3
5
7
Troubleshooting
The appliance does not start or it stops during
operation.
Before you contact the Service, refer to the in-
formation that follows for a solution to the
problem.
22
C
B
A
2
4
D
6
8
To remove filters (B) and (C), turn the handle
counterclockwise and remove. Pull apart filter
(B) and (C). Wash the filters with water.
Remove filter (A). Wash the filter with water.
Before you put the filter (A) back, make sure
that there are no residues of food or soil in or
around the edge of the sump.
Make sure that filter (A) is correctly positioned
under the 2 guides (D).
Assemble filters (B) and (C). Put them back in
filter (A). Turn the handle clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage
to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin poin-
ted object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of grease
and limescale inside the appliance.
To prevent this, we recommend to run long
duration programmes at least 2 times per
month.
With some problems, different indicators
flash continuously or intermittently at
the same time to show an alarm code.
www.zanussi.com