Zanussi ZDI12010XA Notice D'utilisation page 18

German
degrees
(°dH)
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
How to adjust the level of the water
softener
1. Make sure that the programme marker on
the knob is aligned with the on/off indica-
tor.
2. Press and hold the delay button. At the
same time turn the knob counterclockwise
until the programme marker is aligned with
the first programme.
3. Release the delay button when the start in-
dicator and the on/off indicator start to
flash.
4. Press the delay button.
•
starts to flash.
• The start indicator and the on/off indica-
tor continue to flash.
• The intermittent flashing of
the current set level, e.g. 5 flashes +
pause + 5 flashes = level 5.
5. Press the delay button again and again to
change the setting. Each time you press
the delay button the level number increa-
ses.
6. To confirm the setting and deactivate the
appliance, turn the knob until the pro-
gramme marker is aligned with the on/off
button.
Filling the salt container
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after you fill
the salt container, start a programme.
18
Water hardness
French mmol/l
degrees
(°fH)
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
refers to
Clarke
degrees
13 - 17
5 - 12
< 5
1
3
Put 1 litre of water in the salt container (only
for the first time).
Filling the rinse aid dispenser
1
Water softener
adjustment
Level
3
2
2)
1
2
4
2
1
2
www.zanussi.com