Zanussi ZDI12010XA Notice D'utilisation page 19

A
3
Daily use
1. Open the water tap.
2. Turn the programme knob until the pro-
gramme marker is aligned with the pro-
gramme you want to set. Make sure that
the appliance is in setting mode, refer to
"Setting and starting a programme". Set
the correct programme for the type of load
and the degree of soil.
• If the salt indicator is on, fill the salt con-
tainer.
3. Load the baskets.
4. Add the detergent.
5. Start the programme.
Using the detergent
1
www.zanussi.com
1
2
4
1
2
2
Fill the rinse aid dispenser when the lens
(A) is clear.
To adjust the released quantity of rinse aid,
turn the selector between position 1 (lowest
quantity) and position 4 (highest quantity).
A
B
3
Put the detergent or the tablet in compartment
(A) If the programme has a prewash phase,
put a small quantity of detergent in compart-
ment (B).
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser. The rinse aid indicator al-
ways comes on if the rinse aid dispenser is
empty.
1. Adjust the water softener to the lowest lev-
el.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the
rinse aid dispenser are full.
4
19