Metabo HPT NR 90AC5 Manuel D'instructions Et De Sécurité page 21

NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 4 – 8).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
1 DISCONNECT AIR HOSE.
2 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
Rod
Outlet
3 Remove the jammed nail with a slotted screw
driver.
4 In case of frequent jam, contact a metabo HPT
authorized service center.
MAINTENANCE
WARNING
1
Disconnect
air hose
2. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove plastic chips or
wooden chips which may have accumulated in the
magazine. Lubricate it with metabo HPT pneumatic
tool lubricant.
Cloth
CAUTION
● Check that the nail feeder slides smoothly by
pulling it with fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
3. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
○ Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
4. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
English
1
Disconnect
air hose
Warning Label
21