Sony VPH-D50Q Manuel D'installation page 23

8 INPUT A connectors (BNC type)
R/R-Y/P , G/Y, B/B-Y/P
R
connectors: Connect to the outputs of a computer or
a video camera. According to the connected
equipment, the RGB (R, G, B), component (R-Y, G,
B-Y) or HDTV (P , Y, P
R
9 Signal interface board attachment part (INPUT
B)
The IFB-40 Signal Interface Board is installed by
default. Other optional signal interface boards can be
attached to this section instead of the IFB-40.
Indicator (red): Lights up when the input of the IFB-
40 is selected.
REMOTE 1 IN connector (14-pin multi): When
connecting two projectors, connect to the REMOTE
1 OUT connector on the IFB-40 installed to another
projector.
REMOTE 1 OUT connector (14-pin multi):
Connect to the REMOTE 1 IN connector on the
IFB-40.
MODE selector: Turn the control switch of the
MODE selector to the appropriate position
according to the length of the cable connected to the
REMOTE 1 OUT connector.
Cable length
up to 2 m up to 10 m
Type of cable
SIC-M-1
CCQ-5BRS
CCQ-2BRS CCQ-10BRS
1
Position
, SYNC/HD, VD
B
) signal is selected.
B
up to 25 m up to 50 m
SIC-M-15 SIC-M-50
SIC-M-5
CCQ-25BRS CCQ-50BRS
SIC-M-25
2 3 4
Front
0 AC IN socket
Connect the supplied AC power cord.
!¡ MAIN POWER switch
!™ Front remote control detector
23
Connections (EN)