Sony VPH-D50Q Manuel D'installation page 29

When the switcher is connected to the projector using the 5BNC cables (5BNC mode 2)
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
CONTROL S IN
Remote control
cable (supplied)
When the switcher to be connected is more than 50 m away from the
projector, or the SIC-M or CCQ-BRS cable cannot be used for the
connection between the projector and switcher, connect the RGB signal
sources to the switcher and the video signal sources to the projector.
Rear
IN OUT
ABL LINK Y IN C IN
R
IN OUT IN OUT R-Y/P
INDEX VIDEO S VIDEO
S
VIDEO IN VIDEO
IN
to S
to video video
output output
Video
equipment
to CONTROL S
OUT
PC-1271/1271M
Switcher
15 K RGB/HD/
Video
component
equipment
equipment
Setting up
• Set INPUT-A to RGB and 5BNC MODE to ON in the SET SETTING
menu.
For details, see "The SET SETTING Menu" on page 50 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see "The INPUT SELECT Menu" on page 44 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• When the HDTV signal is input to the switcher, set the output of the
connected equipment or the IFB-1301 Signal Interface Board installed to
the switcher to GBR OUT.
• When the component signal is input to the switcher, set the output of the
connected equipment or the IFB-1200 Signal Interface Board installed to
the switcher to RGB OUT.
G B SYNC/HD VD
REMOTE1
Y B-Y/P
R B
INPUT A
IN
5BNC cables
to MONITOR OUT
Computer Computer
MODE
OUT
29
Connections (EN)