Installation Procedures - Sony VPH-D50Q Manuel D'installation

Installation Procedures

4
(EN) Installation
By default, this projector is adjusted for 120-inch front projection on the
floor/desk. If you install the projector in other conditions, you have to
change some settings. Therefore, installation procedures depend on the
screen size or type, and installation method.
1 Ver ify the conditions of installa tion, such as angle of optical axis,
projection distance, height of the projector and screen.
.
2 Chang e the polar ity accor ding to the pr ojection pa tter ns. (page 17 (EN))
.
3 Install the pr ojector and scr een. (page 9 (EN))
.
4 Reset the r egistr ation da ta to f actor y setting . (page 101 (EN))
.
5 Adjust the CR T conver sion angle . (page 20 (EN))
.
6 Adjust the lens f ocus and f lapping of the lens. (page 62 (EN))
.
7 Adjust the r egistr ations. (page 68 (EN))
.
8 Connect other equipment. (page 26 (EN))
.
9 Adjust eac h input signal. (pages 91 (EN) to 97 (EN))
• Fine adjustment for the registrations. (pages 91 (EN) and 94 (EN))
• Adjust the size or shift of the picture. (pages 92 (EN), 94 (EN) and
95 (EN))
• Adjust the blanking. (pages 93 (EN) and 95 (EN))