Location And Function Of Connectors - Sony VPH-D50Q Manuel D'installation

Location and Function of Connectors

1 2
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
5
Rear
1 TRIGGER connector (minijack)
When the projector is turned on, 5 V is output and
when it is turned off, 0 V is output. However, the
connector is not used as the power source since the
power is not output.
2 RS-422A REMOTE connector (D-sub 9-pin)
Used to expand the system connections using the RS-
422A interface.
Before using the connector, remove the red cap.
3 INDEX NO. switches
When multiple projectors are connected, set the index
number of each projector.
To display the index number on the screen, press the
NORMAL key, and the ENTER key on the remote
control.
Note
If you set the index number to "00," the projector does not
operate.
4 ABL (Automatic Brightness Limiter) LINK IN/
OUT jacks (minijack)
When connecting multiple projectors, connects the
ABL LINK OUT jack to the ABL LINK IN jack on
another projector. You can synchronize the brightness
limiting point among the projectors, allowing to make
the whole screen brightness uniform.
22
(EN) Connections
Rear
3 4
IN OUT
ABL LINK Y IN C IN
OUT OUT
IN IN
INDEX VIDEO S VIDEO
6 7
5 CONTROL S jacks
IN/PLUG IN POWER (5 V) jack (stereo minijack):
OUT jack (stereo minijack): Connects to the
When using this jack, the remote control detector on the
projector does not function.
6 VIDEO IN/OUT connectors
VIDEO IN connector (BNC type): Connects to the
VIDEO OUT connector (BNC type): Connects to
7 S VIDEO IN/OUT connectors
Y IN, C IN connectors (BNC type): Connects to the
S VIDEO IN/OUT connectors (4-pin, mini-DIN
The S VIDEO IN connector is disconnected when a cable
is connected to the Y/C IN connectors.
Front
R G B SYNC/HD VD
REMOTE1
R-Y/P Y B-Y/P
R B
INPUT A IN
8
Connects to the CONTROL S OUT jack of other
Sony equipment. Also connects to the CONTROL
S OUT jack of the supplied remote control with the
supplied remote control cable (stereo cable) to be
used as a wired remote control. In this case, this
jack supplys 5 V to the remote control as power
source.
CONTROL S IN jack of other Sony equipment.
Note
composite video output of the video equipment.
the composite video input of a color monitor.
Y and C video outputs of the video equipment.
type): Connects to the S video output or input
connector of the video equipment.
Note
!™
!¡
!º
MODE
OUT
9