Sony VPH-D50Q Manuel D'installation page 30

Using the Signal Interface Switcher
When two signal interface switchers are connected
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
30
(EN) Connections
Rear
IN OUT
ABL LINK Y IN
IN OUT IN
INDEX VIDEO S VIDEO
Video First switcher
equipment PC-1271/1271M
Video Second switcher
equipment PC-1271/1271M
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable between the projector and the
switcher up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz.
Setting up
• Set the SINGLE/SECOND/OTHER select switch on the first switcher to
SINGLE.
• Set the SINGLE/SECOND/OTHER select switch on the second switcher
to SECOND.
IFB-40 Signal Interface Board
C IN
R G B SYNC/HD VD
REMOTE1
OUT R-Y/P Y B-Y/P
R B
INPUT A IN
to REMOTE 1 OUT
to REMOTE 1 IN
to REMOTE 1 OUT
MODE
OUT
IN
SIC-M or CCQ-BRS
connecting cable
SIC-M or CCQ-BRS cable