Blanking Adjustment; Adjusting The Rgb Input Signal - Sony VPH-D50Q Manuel D'installation

Blanking adjustment

Adjusting the RGB Input Signal

If the displayed picture is larger than the screen, cut off the excess parts.
1
Press the BLKG key.
2
Press the POSITION +/– keys to select the part to be adjusted.
• When you press the + key, the position cycles through the following
order:
TOP → BOTTOM → LEFT → RIGHT → TOP...
• When you press the – key, the position cycles in reverse order.
B L K G A D J
T O P
T : 5 0
B : 5 0
ADJ:
L : M A X
NEXT:
R : 5 0
3
Adjust with the arrow keys.
• Press the V and v keys to adjust the TOP and BOTTOM positions.
• Press the B and b keys to adjust the LEFT and RIGHT positions.
4
Press the MEMORY key to save the adjustment data.
Note
When you connect multiple video input sources to the projector2, such as when
using the switcher, adjust the picture size, picture shift and blanking for each input
connector.
1
Input the RGB signal to the INPUT A connectors on the projector or to
the signal interface board installed to the INPUT B section.
2
Press the INPUT SELECT A or B key on the remote control to select
the RGB input signal.
3
Fine adjust the registration if necessary.
For details, see "Adjusting the Registration" on pages 68 (EN) to 90 (EN).
+ –
93
Adjustments (EN)