Location And Function Of Controls; Top/Front/Left Side; Rear/Right Side/Bottom - Sony VPL-ES1 Mode D'emploi

Location and
Function of Controls

Top/Front/Left Side

Rear/Right Side/Bottom

4
5
6
7
8
9
1 Control panel
For details, see "Control Panel" on
page 11.
2 Lens protector (lens cover)
The lens protector automatically opens
when the power is turned on.
3 Ventilation holes (exhaust)
4 Remote control detector
5 Adjuster (hind pad)
Turn the adjuster to the right or left for
minor tilt adjustment of the projected
picture.
10
GB

Location and Function of Controls

6 Ventilation holes (intake)/Lamp
cover
7 Ventilation holes (intake)/air
filter cover
Notes
• Do not place anything near the
ventilation holes as it may cause
internal heat build-up.
• Do not place your hand or objects
near the ventilation holes as it may
cause the air coming out heat build-
up.
• To maintain optimal performance, clean
the air filter every 500 hours.
For details, see "Cleaning the Air
Filter" on page 41.
8 Ventilation holes (intake)
9 Powered tilt adjuster
0 Indicators
0
POWER SAVING
Lights up when the projector is in power
saving mode. When "Power Saving" in
qa
the SET SETTING menu is set to "ON,"
the projector goes into power saving
qs
mode if no signal is input for 10 minutes.
Although the lamp goes out, the cooling
qd
fan keeps running. The power saving
qf
mode is canceled when a signal is input
or any key is pressed. In power saving
qg
mode, any key does not function for the
first 60 seconds after the lamp goes out.
TEMP (Temperature)/FAN
Lights up or flashes under the following
conditions:
– Lights up when temperature inside the
projector becomes unusually high.
– Fashes when the fan is broken.
For details on the TEMP/FAN indicator,
see page 44.
LAMP/COVER
Lights up or flashes under the following
conditions:
– Lights up when the lamp has reached
the end of its life or becomes a high
temperature.