Franke FHSM 604 4I BK Manuel D'installation page 8

FHSM 604 4I / FHSM 603 3I / FHSM 603 3I DZ / FHSM 603 3I SZ / FHSM 804 4I /
EN
FHSM 803 3I / FHSM 302 2I / FHSM 604 4I WH / FHSM 603 3I DZ WH
Installation procedure
Explanation for positions in illustrations (page 3, 4, 5 and 6)
1
Cut-out dimension
2
Kitchen furniture
3
Monophase connection
4
Twophase / Triphase connection
1
Electrical connection
Refer to the information in chapter „Electrical connection" before connecting the
X Z
appliance.
Connect the appliance like shown in the diagram (in accordance with the mains
X Z
voltage).
2
Ventilation
The illustration on page 6 shows one example of installation suitable for proper
X Z
ventilation and one example of incorrect installation to be avoided.
3
Hob seal
To prevent leakage of liquid between the frame of the hob and the countertop,
X Z
place the adhesive seal provided along the entire outer edge of the hob before
assembly.
Basic adjustment of sensors to the ambience
Upon each connection to the power supply the sensors of the appliance are
Z Z
automatically adjusted to the environment to ensure their proper function. All
displays turn on and are fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects,
Z Z
otherwise the adjustment procedure will be interrupted until such objects are
removed from the sensor surface. During this period the regulation of the cooktop
is impossible.
– 8 –