Franke FHSM 604 4I BK Manuel D'installation page 7

FHSM 604 4I / FHSM 603 3I / FHSM 603 3I DZ / FHSM 603 3I SZ / FHSM 804 4I /
FHSM 803 3I / FHSM 302 2I / FHSM 604 4I WH / FHSM 603 3I DZ WH
INSTALLATION
Installation must be carried out in compliance with current standards and
regulations.
Installation must be only carried out by specialized and licensed personnel.
Identification plate
The identification plate is located underneath the appliance.
Cabinet requirements
The images on page 3 represent recommended installation. If the dimensions are
different, any modifications are the responsibility of the installer.
The cooking hob is intended to be built into the worktop above a kitchen cabinet of
Z Z
600 mm width or more.
If fitting in flammable material, the guidelines and standards for low voltage
Z Z
installations and for the fire protection must be strictly observed.
For fitted units, the components (plastic materials and veneered wood) must be
Z Z
assembled with heat-resistant adhesives (min. 100°C): Unsuitable materials and
adhesives can result in warping and detachment.
The kitchen cabinet must allow sufficient room for the electrical connections of the
Z Z
appliance. Suspended kitchen cabinets above the appliance must be installed at a
distance that provides enough room for comfortable working process.
The use of hard wood decorative borders around the worktop behind the appliance
is allowed, in this case the minimum distance remains as indicated on the
installation illustrations.
The minimum distance between the built-in appliance and rear wall is indicated at
the illustration for the installation of the built-in appliance (150 mm for the side wall,
40 mm for the rear and 500 mm minimum for any cabinets above it).
As shown on page 3, the appliance bottom thickness is 55 mm.
When installed above a drawer or cabinet the hob must be fitted with a horizontal
Z Z
plate 20 mm away from the worktop's bottom surface. When installed above an
oven it is not necessary to add the horizontal plate. The space between the plate
and the appliance must be empty and no objects may be stored or kept inside it.
Incorporation of the oven under the appliance is permissible for ovens equipped
Z Z
with a cooling fan.
– 7 –
EN