VALBERG MFO 66 P K CD 765C Consignes D'utilisation page 15

B
Using the appliance
Opening the terminal board:
• Using a screwdriver, prize the bolt on the side tabs of the terminal board cover;
• Using a screwdriver unhooking the no.2fixing hooks, pull open the cover of the terminal board.
To install the cable, proceed as follows:
• Remove the wire clamp screw and the three contact screws L-N -
• Fasten the wires beneath the screw heads using the following color scheme :
Blue (N) Brown (L) Yellow-Green
• Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
• Install a standardized plug corresponding to the load indicated on the data plate. When
connecting the cable directly to the mains, install an omni polar circuit breaker with a minimum
contact opening of 3 mm between the appliance and the mains. The omni polar circuit breaker
should be sized according to the load and should comply with current regulations (the earth
wire should not be interrupted by the circuit breaker).
• The supply cable should be positioned so that it does not reach a temperature of more than
50°C with respect to the room temperature, anywhere along its length, or protected by insulation
sleeping having an appropriate rating.
Before making the connection, check that:
• The electrical safety of this appliance can only be guaranteed if the cooker is correctly and
efficiently earthed, in compliance with regulations on electrical safety. Always ensure that the
earthling is efficient; if you have any doubts call in a qualified technician to check the system.
The manufacturer declines all responsibility for damage resulting from a system which has
not been earthed.
• Before plugging the appliance into the mains, check that the specifications indicated on the
date plate (on the appliance and /or packaging) correspond to those of the electrical mains
system of your home.
• Check that the electrical capacity of the system and sockets will support the maximum power of
the appliance, as indicated on the data plate. If you have any doubts, call in a qualified technician.
8 EN