Publicité
Les langues disponibles
Les langues disponibles
If the value of channel A is set between 0 to 10, the unit is off.
While the value is set between 11 to 255, the unit is on.
Note: Once DMX cable is connected to the unit, then the LCD control panel, W-1
transmitter and HC-1 controller connected cannot be used.
CAUTION
Never drink haze fluid. If feel sick after ingesting in any case, call the
!
doctor immediately. If haze fluid comes in contact with skin or eyes,
rinse thoroughly with cold water.
- The fan located at the rear of the machine is set to stop 60 seconds after the output is
terminated for the purpose of radiating. Thus it is advised to power off the machine after the
termination of fan.
- If you have followed the above operation steps, and you still experience low output,
mechanical noise or no output at all, unplug the unit immediately from the mains. Check the
fluid level, the external fuse, the remote control connection, and the power cable from the
wall. If all of the above appears to be O.K., plug again. If the hazer is still not functional,
discontinue operating otherwise it may result in permanent damage to the unit. Return the
machine to your Antari dealer. Always drain tank before sending the unit.
DMX CONNECTOR PIN ASSIGNMENT
The machine provide 5 pin XLR connector for DMX connection. Diagram below indicate pin
assignment information
All manuals and user guides at all-guides.com
Pin
1
2
3
8
Function
Ground
Data-
Data+
Publicité
