Publicité
Les langues disponibles
Les langues disponibles
D. Pull LOWERING valve handle to lower,
SAFETY
INSTRUCTIONS
Fig. 3.
Note: Both LATCH release and
LOWERING valve handles are deadman-
type design. Each must be held down to
lower lift . Do not override self-closing lift
controls.
Proper maintenance
and inspection
is necessary
for safe operation.
c
7. Remain clear of lift when lowering
vehicle. Observe pinch point warning
decals.
8.
Remove adapters from under vehicle and swing arms to full
drive-thru position before moving vehicle.
9.
If lift is not operating properly, Do Not use until adjustment or
repairs are made by qualified lift service personnel.
*Maximum operation pressure is:
3263 psi for Standard
3263 psi for Hummer
3263 psi for Sprinter
Typical Lift Points
Do not operate
a damaged lift.
Truck
Spotting Dish
Latch
Release
Latch
Release
Fig. 3
All manuals and user guides at all-guides.com
Truck Frame
Lift
Adapter
A
Section "A - A"
A
Lift Controls
Raise
Switch
Lowering Valve
Handle
Raise
Switch
Lowering
Valve
Handle
SAFETY
INSTRUCTIONS
Do not operate
Remain clear of lift
a damaged lift.
when raising or
lowering vehicle.
©
SAFETY
INSTRUCTIONS
Do not override
Proper maintenance
and inspection
self-closing
is necessary
lift controls.
for safe operation.
c
Typical Wheel Spotting Positions
Most specialty or modified vehicles cannot be
WARNING
raised on a frame engaging lift. Contact vehicle
manufacturer for raising or jacking details.
Positioning the vehicle
Due to varying centers of gravity within different vehicle
classes, use the dish as a guide only and locate the arms
between the vehicle pickup points. Always position vehicle
with its center of gravity in line with lift columns. Slightly raise
vehicle and check for stability. Do this by pushing up & down
on the front and rear bumpers. The vehicle should sit firmly on
all pickup points. If necessary, relocate arms and/or vehicle to
attain a stable condition. Also refer to the ALI Safety Manual
included with the lift.
5
WARNING
WARNING
Keep feet
clear of lift
while lowering.
©
CAUTION
Always use
safety stands when
removing or installing
©
heavy components. ©
Less than 105"
wheelbase:
position left front
wheel on approach
side of wheel dish.
105"-127"
wheelbase:
position left front
wheel in wheel
dish.
Larger than 127"
wheelbase:
position left front
wheel just forward
of wheel dish.
©
Fig. 1
Publicité
