Inserting/Removing Battery; Operation; Switching On And Off; Troubleshooting - TOOLCRAFT TCWS 20-LI Solo Mode D'emploi Original

d) Inserting/removing battery
• Slide the battery into the battery compartment (4) as shown until it clicks
into place.
• To remove the battery, press the release button on the battery and pull it out
of the battery slot (4).

8. Operation

Switching on and off

• To switch it on, push the on/off switch (3) to the right and then slide it up.
• To switch the appliance off, slide the on/off switch (3) back to its original
position.

9. Troubleshooting

The disc grinder does not switch on:
• The battery has depleted. Charge the battery using the corresponding charger.
• The battery is not correctly inserted into the battery compartment (4).
The disc does not rotate:
• Immediately switch off the disc grinder and disconnect the battery from the appliance.
• Check if a foreign object is blocking the disc grinder.
• Check whether any part in the guard are jammed.
• If necessary, remove the disc and/or remove the foreign object.
30