Vortice VORT HRW 20 MONO Livret D'instructions page 28

ENGLISH
On all models it is necessary to reset the saturated filter status (LED on) after cleaning/replacing the filter, by taking the
following action:
set the speed selector A onto "0" /
Actuate the operating mode selector B 3 consecutive times within a maximum time of 2s. To confirm the reset, the LED will
flash 3 times and then turn off. (fig. 47,48)
47 47
3x
B
We also recommend calling a Technical Support Centre once a year to have the appliance and its internal filters cleaned.
N.B. Failure to clean or replace filters can affect system efficiency, causing:
- increased loss of pressure in the air circulation system and reduced airflow;
- subsequent drop in system performance and in comfort levels.
Important information concerning the environmentally compatible disposal
This product complies with Directive 2012/19/EU on the management of waste electrical and electronic equipment
(WEEE).
The crossed-out wheeled bin symbol on the appliance indicates that, at the end of its life, the product should
not be discarded together with household waste but must be taken to a separate collection point for electrical
and electronic equipment. This will avoid negative effects on the environment and health, and will encourage
correct treatment, disposal and recycling of the materials from which the product is made.
Contact the municipal authority for the location of this type of facility. Alternatively, the distributor is obliged to take back the
appliance to be disposed of free of charge in exchange for the purchase of an equivalent appliance.
28
48 48
A
B
3x
A