Publicité
Everest III User Guide
Control panel
The control panel is located on the front of the printer. It includes an operator button and
four indicator lights. The control panel allows you to monitor and control the Everest printer.
Tip: If all indicator lights are blinking, the printer did not initialize properly. To correct
this issue:
1.
Remove the power cord. The Everest printer powers down.
2.
Set the mode switch to the proper position. For more information, refer to the table
on page 5.
3.
Connect the power cord. The Everest printer powers on.
Control panel indicators
Image
Name
Operator Button
Error indicator light
Disc Present indicator
light
Active indicator light
Power indicator light
4
All manuals and user guides at all-guides.com
Functionality
The Operator button is used to complete the following tasks:
• Open the printer tray
• Close the printer tray
• Reset after an error
• Put the printer in sleep mode
Tip: To put the printer into sleep mode, press and hold the
Operator button for 10 seconds. Press the Operator button
again to resume normal operation.
The Error indicator light, located on the operator button,
illuminates when operator action is required.
The Disc Present indicator light illuminates when a disc is
placed on the tray or when the disc is properly clamped.
The Disc Present indicator light flashes when an Everest print
latch is open or a ribbon is not detected.
The Active indicator light illuminates when the printer has
completed initialization.
The Active indicator light flashes when the Everest printer is
receiving data from the host.
The Power indicator light illuminates when the Everest printer is
powered on.
110875_B
Publicité
