Publicité
Clean the tacky rollers with the Everest cleaning kit
1.
Power off the printer.
2.
Remove the print ribbon. For specific instructions, see
Changing the print ribbon. Refer to page 17.
3.
To access the tacky rollers, remove the supply roll from the
print ribbon carrier.
Note: The supply roll is the unused portion of the print
ribbon.
4.
Clean the tacky rollers.
a.
Apply isopropyl alcohol to the sponge swab.
b.
Use the sponge swab to clean tacky roller 1.
c.
Use the sponge swab to remove any waxy buildup from
other parts of the ribbon carrier.
d.
Reinstall the supply roll on the print ribbon carrier.
e.
Inside the printer, use the sponge swab to wipe tacky
roller 2.
5.
Prepare the printer for use.
a.
Install the print ribbon carrier.
b.
Close all latches.
c.
Close the side cover.
6.
Power on the printer. The printer is ready for use.
Clean the air filter
1.
Power off the printer.
2.
Remove the air filter.
a.
At the rear of the Everest printer, remove the
two screws holding the fan cover.
b.
Remove the air filter.
3.
Clean the air filter.
a.
Use water to clean the air filter.
b.
Allow the air filter to dry.
4.
Prepare the printer for use.
a.
When the air filter is dry, place it inside the fan cover.
b.
Use the two screws to attach the fan cover.
5.
Power on the printer. The printer is ready for use.
110875_B
All manuals and user guides at all-guides.com
Maintain the Everest printer
Print
ribbon
carrier
Print ribbon carrier
Fan cover
Tacky
roller 1
Tacky
roller 2
Screws
21
Publicité
