Publicité
Compliance testing
Product name: Everest III printer
Model: CDPR22
Notice for USA
Federal Communications Commissions (FCC) Warning
Any unauthorized modification to this equipment may result in the revocation by the FCC of the
user's authority to operate this equipment.
Federal Communications Commissions (FCC) Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC/IC radiation exposure limits set forth for uncontrolled equipment
and meets the FCC/IC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This
equipment has very low levels of RF energy that is deemed to comply without maximum permissive
exposure evaluation (MPE). But it is desirable that it should be installed and operated with at least 8
in (20 cm) or more between the radiator and the person's body (excluding extremities: hands, wrists,
feet and legs).
Additional FCC Notices
Properly shielded and grounded cables and connectors must be used for connection to host
computer and/or peripherals in order to meet FCC emission limits.
Safety precautions for RF exposure
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
Product Safety Statement
This product complies with UL 60950-1.
Notice for Canada
Canadian Department of Communications (DOC) Statement
This Class B digital apparatus complies with Canadian ICES-003 Issue 3:1997. Cet appareil
C
numerique de la classe B est conforme a la norme NMB-003 du Canade.
This product complies with CAN/CSA-C22.2 No. 60950-1-03 1
Notice for Europe
This product is in conformity with the EMC Directive (89/336/EEC) and the Low-Voltage Directive
(73/23/EEC) through compliance with the following European standards: EN 60950:2000, EN
55022:1998 + A1:2000 & A2: 2003, EN 55024:1998 & A1: 2001& A2: 2003, EN 61000-3-2:2000;
EN 61000-3-3:1995 & A1: 2001. The CE mark has been affixed in accordance with the CE Marking
Directive 93/68/EEC.
Hereby, Rimage Corporation declares that this equipment Everest III printer, model CDPR22 is in
compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
Notice for Japan
VCCI
This product complies with VCCI V.3/2005.04
110875_B
All manuals and user guides at all-guides.com
Learn More
st
edition.
Notice for Australia
CTICK
This product complies with
AS/NZS CISPR22:2004
25
Publicité
