Publicité
Everest III User Guide
Operate the Everest printer
This section provides the information needed to use your Everest printer.
Powering on and off the Everest printer
The Everest printer does not have a power switch:
Notes:
•
The printer goes into sleep mode if it is idle for more than 30 minutes. When this occurs, the printer will
take 2-3 minutes to warm up after a job is sent to the printer.
•
If the Everest printer is a standalone printer, connect the power cord from the Everest printer to a power
outlet to power on the printer. To power off the Everest printer, disconnect the power cord.
Installing the Everest printer driver
Before printing, you must install the printer driver. This section provides instructions for installing the Everest
printer driver on a Windows PC or a Macintosh.
Important! To install the Everest printer driver, you must be logged on with an administrator account.
Install the Everest printer driver (PC)
Use these instructions to install the printer driver on a Windows PC.
Important! If your Rimage Everest printer was included with an aut
control center, the Everest printer driver is alread
1.
Connect the Everest power cord to the printer.
2.
Ensure that the Everest printer is powered on.
Note: If the Everest printer is a standalone printer (not on an autoloader), the Everest printer powers on
when you connect the power cord. If the Everest printer is on an autoloader, the Everest printer powers
on when you powe
printer
on page 6.
3.
Connect the USB cable from the Everest printer to the computer.
4.
Insert the software disc i
Rimage software disc.
6
All manuals and user guides at all-guides.com
y installed.
r on the autoloader. For more information, refer to
n the computer disc drive. The printer driver will automatically install from the
oloader that has an embedded PC or a
Powering on and off the Everest
110875_B
Publicité
