Publicité
Everest III User Guide
4.
Install the new print ribbon.
a.
Remove the new print ribbon
from the packaging.
b.
Install the supply roll end of the
print ribbon on the top of the
carrier.
c.
Insert the large shaft in the large
opening and press the small shaft
into place.
Note: The ribbon must go
over the tacky roller.
d.
Wrap the ribbon around the guide
rollers.
e.
Install the take up roll.
f.
Rotate the take up roll so the ribbon is
aligned and lies flat.
Tip: You may need to lift the ribbon up
from the tacky roller to straighten it.
Note: If you installed a monocolor
ribbon, advance the ribbon so that the
ink portion of the ribbon is advanced to
the take up roll.
5.
Reassemble the printer.
a.
Slide the print ribbon carrier into the printer.
b.
Close latch 1.
c.
Close the side cover.
9.
Power on the printer. The printer is ready for use.
18
All manuals and user guides at all-guides.com
Large
opening
Supply roll
Pull handle
Small
Tacky roller
shaft
Guide rollers
Supply roll
Take up roll
110875_B
Publicité
