Abus TVIP11502 Mode D'emploi page 91

Use the following IP address:
Use the following DNS server address:
Primary DNS server:
Secondary DNS server:
Accept the settings by pressing "SAVE" or cancel them by pressing "Cancel".
WPS (TVIP11552 only)
WPS (Wi-Fi Protected Setup) is a simple method for establishing a secure wireless network connection
(WPA, WPA2). Consult the manual for your access point (e.g. router with WPS function) regarding the
necessary steps for setting up the WPS function.
WPS:
MAC address:
IP address:
Configure via:
Connect: A connection is established via WPS with the selected procedure (PBC or PIN).
Manual setting of the IP address, subnet mask, and standard router
(gateway)
Enable the WPS function here if required.
Shows the MAC address of the wireless interface.
The set IP address is displayed here. The address can be assigned automatically
(DHCP) or manually (see below).
PBC:
Push Button Configuration – You set up a secure wireless connection by pressing
the button on the access point or network camera.
PIN:
A secure wireless connection is set up in the network camera and access point
through the assignment of a PIN. Press the "Generate new PIN" button to assign a
new random PIN. This PIN must then be made known in the access point (WPS
settings). Press "Start". The network camera and access point are then
automatically connected to each other via a secure connection.
If the DNS server address is not automatically assigned by
a DHCP server, it can be manually assigned here.
First server address with which the camera attempts to
convert DNS names into IP addresses.
Alternative server address with which the camera attempts
to convert DNS names into IP addresses.
91