Abus TVIP11502 Mode D'emploi page 64

4.2 Status LEDs
LED
Network info LED
Status info LED
4.3 Using the microSD slot
Disconnect the power supply before inserting the microSD
card.
The microSD card can only be inserted into the socket in a specific
position. The card protrudes out of the slot by about 4 mm when
positioned correctly.
The card is detected by the camera when the power supply is
reconnected, and can then be used as desired.
The microSD card cannot be replaced when the system is in
operation!
4.4 Restoring the factory settings
Camera restart
Restoring the factory settings
Color
Off
purple / blue flashing
(high frequent)
Blue flashing (high
frequent)
Red on continuousely
Blue on continuousely
Press the button until the blue LED goes out -> constantly red
during camera restart -> constantly blue after successful
camera restart
Press the button until the LED lights up blue constantly ->
constantly blue after successful camera restart
Description
Network cable not connected or wireless mode
Start-up procedure
Start-up procedure finished, normal working mode
Start-up procedure
IP address successfully assigned (Note: On manual
setup of IP address, a wrong IP address can be
applied. In this case the blue LED is continuously on
as well)
64